HTTP post

Home Forums M2M Support Forum HTTP post

This topic contains 1 reply, has 2 voices, and was last updated by  Admin 5 years, 9 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #5952 Reply

    Gokul

    Hello Sir,

    May I know how to send continuous data stream coming from serial port of telit Gl-865 on to webserver. At present I am using HTTP POST request and uploading but the problem I am facing here is that data will uploaded on to remote database only for 14 times and after that it disconnects and again after say 20 sec it starts uploading data.. may I know the problem and solution to it.

    Thank you
    Regards
    Gokul

    #5992 Reply

    Admin
    Keymaster

    Is the socket getting closed automatically? After it stops, can you check the status of the socket,
    AT#SS?

    Also try increasing the socket inactivity timer if you suspect there is delay in between sending the data. The default is set to 90 sec.

    AT#SCFG?

    #SCFG: 1,1,300,90,600,50
    #SCFG: 2,1,300,90,600,50
    #SCFG: 3,1,300,90,600,50
    #SCFG: 4,2,300,90,600,50
    #SCFG: 5,2,300,90,600,50
    #SCFG: 6,2,300,90,600,50

    OK

Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: HTTP post
Your information: