+CEER: Regular deactivation, when connecting to GPRS using AT Cmd

Home Forums M2M Support Forum +CEER: Regular deactivation, when connecting to GPRS using AT Cmd

This topic contains 0 replies, has 1 voice, and was last updated by  sunil Tiwari 5 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #11284 Reply

    sunil Tiwari

    Hello Sir,
    Hope u r doing best, I am using AT-command-teester to setup GPRS Connection(TCP) below are the AT commands that i executed, I have obtained IP Address successfully for GPRS connection, but when i try to Enter data state using +CGDATA=1, i get ERROR, with +CEER: Regular deactivation.
    it has been more than a weak I am stuck at this point, Please help.
    AT+CGATT=1
    OK
    AT+CGATT?
    +CGATT: 1
    OK
    AT+CGDCONT?
    +CGDCONT: 1,”IP”,”rcomwap”,”0.0.0.0″,0,0
    +CGDCONT: 2,”IP”,””,”0.0.0.0″,0,0
    +CGDCONT: 3,”IP”,”rcomnet”,”0.0.0.0″,0,0
    OK
    AT+CGPCO=0,””,””,1
    ERROR
    AT+CGACT=1,1
    OK
    AT+CGACT?
    +CGACT: 1,1
    +CGACT: 2,0
    +CGACT: 3,0
    OK
    AT+CGPADDR=1
    +CGPADDR: 1,”10.95.241.53″
    OK

    AT+SDATACONF=1,”TCP”,”www.sina.com.cn”,80
    ERROR
    AT+CEER
    +CEER: Regular deactivation
    OK

    AT+CGDATA=1
    ERROR
    AT+CEER
    +CEER: Regular deactivation
    OK

    Thank’s in Advance
    Sunil Tiwari

Viewing 1 post (of 1 total)
Reply To: +CEER: Regular deactivation, when connecting to GPRS using AT Cmd
Your information: