AT Commands not working over UART/SPI/I2C for SIM7600E

Home Forums M2M Support Forum AT Commands not working over UART/SPI/I2C for SIM7600E

This topic contains 0 replies, has 1 voice, and was last updated by  Swastik 5 months, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #43125 Reply

    Swastik

    Hi M2M support,
    I started working with the SIM7600E recently and tried to communicate it with UART/SPI/I2C with ESP32 board but was unable to execute any commands. The module is working fine with FTDI board though, all the commands run as expected.

    I am using micropython on esp32 board with baud rate 115200/9600 on UART.
    Can you please tell me where am i going wrong?
    Thanks.

Viewing 1 post (of 1 total)
Reply To: AT Commands not working over UART/SPI/I2C for SIM7600E
Your information: